Troubleshooting - Minolta Dimage V Instruction Manual

TROUBLESHOOTING

Refer to these pages to determine the cause of a problem you are
experiencing with your camera. If the information does not cover the
problem which you are experiencing or the condition continues,
contact your nearest Minolta Service Facility.
No image appears in the LCD monitor.
• The camera is turned off.
- Press the main switch to turn the camera on.
• The batteries are exhausted.
- Replace all the batteries with new ones.
• There is no image memory card in the camera.
- Turn the camera off, then insert an image memory card (page 29).
The shutter will not release.
• The image memory card is full.
-There are several options to reclaim space:
• Delete unwanted images.
• Transfer images to a floppy disk or PC hard drive (refer to the
enclosed software manual) then Clear or Format the card.
• Clear or Format the card.
• Use a new image memory card.
• The image memory card is write-protected.
-Remove the write-protect sticker from the image memory card.
See the instructions included with the image memory card.
• There is no image memory card in the camera.
-Turn the camera off, then insert an image memory card (page 29).
The image on the LCD is dark.
• The LCD brightness has been set to minimum.
- Adjust the brightness (page 22).
72
The flash does not fire.
• The lens unit is not in the standard position.
- Put the lens in the standard position so the flash will fire (page 27).
• Recharging is not finished.
- Wait until recharging is finished (
• The camera is in Flash Cancel mode.
- Select Auto-flash or Manual Fill Flash by pressing the flash mode
button (page 34).
stops blinking on the monitor).
73