Warranty And After-Sales Service - Konica Minolta Digital Still Camera KD-30M User Manual

Warranty and After-sales Service

For repair, handling and care, first consult the dealer
from whom you purchased the camera.
Warranty (separately attached)
Before accepting the warranty card, please make sure that the
date of purchase and dealer of purchase and the dealer's details
have been completed. After reading the warranty, keep it in a safe
place.
Warranty period (main unit): one year from the date of purchase
When requesting service
Disconnect the power supply and contact the dealer from whom
you purchased the camera.
Note: Transportation cost for taking/bringing back the
product to/from repair, shipping costs or carrying
charges are at the customer's expense. When shipping
the product, pack the unit appropriately and use a
shipping method such as registered mail or express
mail to prevent loss of the product.
During the warranty period
Repairs will be made by the dealer from whom you purchased the
camera according to the contents of the warranty. For repair,
take the product and the warranty to the dealer from whom you
purchased the camera.
Outside the warranty period
Repairable products can be repaired for a charge upon request.
However, the minimum holding period of performance parts for
repairing digital still cameras is 8 years after termination of
production.
Note: Performance parts for repair are parts necessary to
maintain the functions of the product.
66
122mm+-2
Warranty and After-sales Service
FCC Compliance Statement:
Declaration of Conformity
Responsible party: KONICA PHOTO IMAGING
Address: 725 Darlington Avenue Mahwah, NJ 07430, U.S.A.
Telephone number: (201) 574-4000
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions:
(1) this device may not cause harmful interference and (2) this device
must accept any interference received, including interference that
may cause undesired operation.
This equipment has been tested and found to comply with the limits for a
class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Shielded cables must be used for this equipment to comply with the relevant
FCC regulation.
Power requirement is DC 3.3V 10% and 2.0A max. Use only listed certified
power supply adapter.
The user is cautioned that changes and modifications made to the
equipment without approval of the manufacturer could void the user's
authority to operate this equipment.
Tested To Comply
With FCC Standards
FOR HOME OR OFFICE USE
However, note that operation of this unit near a radio or television
receiver could possibly cause radio disturbance.
67