INSTALLING THE BATTERY
Your camera uses one 3-volt CR-2 battery to supply power
for all camera operations.
• Remove dirt and moisture from the camera and battery before
opening the battery chamber cover.
1. Using a coin, open the battery chamber door as
shown.
2. Insert the battery into the chamber as indicated by
the + and - marks.
3. Snap the battery chamber door shut.
• After installing a new battery,
panel. Reset the date and time. (see p. 55)
20
CHECKING THE BATTERY POWER
Each time the main switch is turned on, a symbol will appear in the data panel to indicate
the power status of the batteries.
Power is sufficient
for all camera ope-
rations.
• If no display appears, replace the battery or check that it is inserted correctly.
• To save power, your camera will shut down and retract the lens if it is not operated for more
will blink in the data
than three minutes. To restore power, close and open the front cover.
• Do not obstruct the lens while it is retracting.
Power is sufficient, but
Replace the battery. The
the battery will have to
shutter will lock until the
be replaced soon.
battery is replaced.
21