Entering Copy mode
Before making copies, make sure that
to enter Copy mode. Copy mode is the default setting.
Loading original documents to copy
To place a document onto the flatbed glass
1
Remove all documents from the ADF (if it is installed).
If you are using the flatbed to scan, do not load any documents into
the ADF.
2
Lift the document cover or ADF lid.
3
Place the original document face down on the flatbed glass and align its
center with the arrow mark on the glass.
Arrow Mark
4
Gently close the document cover or ADF lid. Closing it too quickly may
cause the document to move on the flatbed glass.
5
Customize the copy settings by using the control panel buttons. Refer to
"Setting copy options" on page 61. To cancel settings, press Stop/Reset.
6
Press Start to begin copying.
To load documents into the optional ADF input tray
Do not open the ADF lid while documents loaded into the ADF are
being scanned.
1
Make sure that there is no document on the flatbed glass.
60
is lit in green. Otherwise, press
Entering Copy mode