Electro-Voice ELX112P Owner's Manual page 10

Amplifier Controls (cont')
MAINS IN
AC connection is established via an IEC-connector. For 120V operation, the AC voltage
must be 95V - 132V. For 230V operation, the AC voltage must be 190V - 264V.
A 3m (10') AC cord with fitting IEC-plug is supplied. Extension cords can be used to
lengthen the AC cable as necessary. Make certain they are 3-conductor cables of suit-
able gauge and they are properly grounded to avoid electrical hazards and extraneous
noise.
Under high signal conditions, the Live X loudspeaker amplifier can draw 1.0 amps of
current at 120V, or 0.6 amps at 230V. Be cautious of what else is plugged into the same
electrical service line to avoid electrical problems and poor performance.
POWER
AC switch for switching the power ON or OFF. The switch lights after turning the power
ON. If the LED is not lit upon turning the power on, make sure that the AC cord is cor-
rectly connected and the outlet is properly working.
XLR/TRS INPUT
Electronically balanced input for the connection of high-level signal sources like mix-
ing consoles or signal processors. Connections can be established using 1/4" TRS or
XLR-type connectors. INPUT 2 will accept a microphone input if MIC/LINE switch is
depressed.
MIC / LINE
When depressed, activates a microphone preamp for use with dynamic microphones. A
pen or paperclip is needed to depress the switch to MIC mode.
RCA INPUT
Stereo unbalanced RCA inputs for connecting sources such as CD players or MP3
players. Both RCA inputs are summed and can be controlled with INPUT 1 LEVEL. The
inputs can be used simultaneously with XLR/TRS INPUT 1.
INPUT LEVEL
Level control for adjusting the individual input's amplification. The level control affects the
volume of the individual input section.
10
CAUTION! Do not plug a line level signal into INPUT 2 when MIC/LINE is in
the mic position.
Electro-Voice Live X Series Powered Owner's Manual