Simulation, Trouble Codes - Sharp AL-2030 Service Manual

[10] SIMULATION, TROUBLE CODES

1. Entering the simulation mode
To enter the serviceman simulation mode, press the keys as follows:
Clear → Density select → Clear→ Density select
To cancel the simulation mode, press the clear key.
Flow chart of entering the simulation mode
The current set adjustment
value and the counter
value are displayed on the
COPY QUANTITY
displayed Sensor check,
etc. are displayed by the
alarm lamps, etc.
To change the current set
Perform the operation
values, enter with the COPY
according to the
QUANTITY key.
simulation number.
10th digit:
1st digit:
Count up of values:
COPY QUANTITY key
Count down of values:
Zoom key + COPY
QUANTITY key
The entered value
Press the clear key.
is displayed on the
COPY QUANTITY
display.
All displays on the
operation panel go off,
and the machine enters
Press the COPY
the ready state for
key.
entering the main code.
The entered value
Press the clear key.
is registered.
1
YES
Is there a sub
code ?
NO
Press the COPY
key.
Is it the
simulation for
operation
check?
YES
Is another YES
simulation to be
performed ?
NO
End
AL-2040CS SIMULATION, TROUBLE CODES 10 - 1
Press the COPY key.
The COPY QUANTITY
display blinks to indicate
"00" and the machine
enters the ready
state for sub code input.
Enter the sub code with
the COPY QUANTITY key.
10th digit
1st digit:
Count up of values:
COPY QUANTITY key
Count down of values:
Zoom key + COPY
QUANTITY key
Press the COPY key.
The COPY QUANTITY
display blinks to indicate
the previously set sub
enters the ready 7 state for
sub code input.
code, and the machine
Is the
YES
main code the
Press the clear key.
same ?
NO
Is the
NO
Enter the new main
sub code
displayed ?
YES
The main code is
displayed on the
Press the clear key.
COPY QUANTITY
display.
Start
Press the clear key.
Within 1sec
Press the exposure
mode selector key.
Within 1sec
Press the clear key.
Within 1sec
Press the exposure
mode selector key.
All displays on the
operation panel go off,
and the machine enters
he ready state for entering
he main code.
Enter the main code with
the COPY QUANTITY key.
10th digit:
1st digit:
Count up of values:
COPY QUANTITY key
Count down of values:
Zoom key + COPY
QUANTITY key
code.
The main code is
displayed on the
COPY QUANTITY
display.
1