Service Note; Note For Repair; Power Supply During Repairs - Sony DCR-TRV145E DCR-TRV147E DCR-TRV245E Service Manual

COVER COVER

1-1. NOTE FOR REPAIR

Make sure that the flat cable and flexible board are not cracked of
bent at the terminal.
Do not insert the cable insufficiently nor crookedly.
Cut and remove the part of gilt
which comes off at the point.
(Be careful or some
pieces of gilt may be left inside)

1-2. POWER SUPPLY DURING REPAIRS

In this unit, about 10 seconds after power is supplied to the battery terminal using the regulated power supply (8.4V), the power is shut off so
that the unit cannot operate.
The following method is available to prevent this.
Method 1.
Use the AC power adaptor (AC-L10, AC-VQ800 etc.).
DCR-TRV145E/TRV147E/TRV245E/TRV250E
SECTION 1

SERVICE NOTE

When remove a connector, don't pull at wire of connector.
It is possible that a wire is snapped.
When installing a connector, don't press down at wire of connector.
It is possible that a wire is snapped.
1-1