Alarm Function; Setting The Alarm Time; Activating The Alarm; Snooze Function - Silvercrest KH 2314 Operating Instructions Manual

Alarm Function

You can programme in two alarm times, and then
be woken by either the DAB radio, FM radio or one
of two different alarm signals.
Note:
In mains operation the functions alarm, snooze and
sleep are available without restriction.
In battery operation only the sleep function is available
without restriction. An alarm can of course be
programmed with a switched on radio, however,
it does not switch itself on from the standby mode.

Setting the alarm time

Note:
If no further input is made within 10 seconds, the display
indicates once again the previous mode of operation.
1. Press and hold the buttons
programme the respective alarm. In the display
the indicators Alarm 1 Time Set resp. Alarm 2
Time Set and the alarm time appear. The minute
figures blink.
2. Turn the multi adjustor
in the minutes. Press the button
The hour figures blink.
3. Turn the multi adjustor
in the hours. Press the button
4. Turn the multi adjustor
between the alarm signals BEEP TONE1 or BEEP
TONE2. Press the button
5. Turn the multi adjustor
in a saved position 1-10 (DAB-Preset) for the
DAB mode. Press the button
6. Turn the multi adjustor
in a saved position 1-10 (FM-Preset) for the FM
mode. Press the button
ALARM1 ALARM2
or
VOLUME/SELECT
to programme
JOG MODE/SELECT
VOLUME/SELECT
to programme
JOG MODE/SELECT
VOLUME/SELECT
to choose
JOG MODE/SELECT
.
VOLUME/SELECT
to programme
JOG MODE/SELECT
VOLUME/SELECT
to programme
JOG MODE/SELECT
.
7. Turn the multi adjustor
in a sound volume (Volume Level) from 1-20.
Press the button
The alarm time is now programmed. To activate the
alarm, read the next section.

Activating the alarm

• Repeatedly press the button
to adjust the appropriate alarm as follows:
ON BEEP
ON DAB
ON FM
OFF
Note:
For an alarm call in the DAB mode a sender MUST
be programmed in at the selected save location.
If a sender is not saved there, then the alarm switches
itself on with a signal tone.
Note:
to
When the alarm is activated, a quadrat appears in
the upper left corner of the display.
• With the device switched on, repeatedly press
the button
. or Alarm 2 Status appears, to display the alarm
adjustments.
With an activated alarm, at the adjusted alarm time the
. signal tone resp. the radio sounds for one hour.
• Terminate the alarm by pressing the button
ON
, or deactivating the alarm by pressing the
appropriate button

Snooze Function

. With the snooze function you can extend the alarm
time in 5 minute steps.
• Press the button
In the display the time and Z is indicated.
The alarm stops and sounds again after 5 minutes.
After one hour the alarm switches itself off.
- 10 -
VOLUME/SELECT
JOG MODE/SELECT
.
ALARM1
Alarm activated by alarm signal
Alarm activated in the DAB mode
Alarm activated in the FM mode
Alarm switched off
INFO
until the indicator Alarm 1 Status
ALARM1 ALARM2
resp.
SNOOZE
when the alarm sounds.
to programme
ALARM2
resp.
STANDBY/
.