Get Going; Installing In Your Car; Positioning The Device; Switching On And Off - TomTom Go Reference Manual

Get going

Installing in your car

Use the supplied mount to install your TomTom GO in your vehicle. Read the instructions about
positioning your device before you install your GO.
To install your GO, do the following:
1. Connect the supplied USB cable to the mount. If the mount is integrated into your GO, connect
the USB cable to the device.
Note: Use ONLY the USB cable supplied with your GO. Other USB cables may not work.
2. Connect the USB cable to the USB car charger and plug this into the power supply on your
dashboard.
3. Choose the best smooth location, on your windscreen or side window, to mount your TomTom
GO.
4. Make sure that both the suction cup on the mount and your windscreen are clean and dry.
5. Press the suction cup of the mount firmly against your windscreen.
6. Turn the rubber grip near the base of the mount in a clockwise direction until you feel it lock.
7. If your mount is not integrated into your GO, place your GO in the mount, making sure that it
clicks into place.
Dashboard mount disks are available as part of a range of accessories for your GO. For more
information, go to tomtom.com/accessories.

Positioning the device

Be careful where you install your GO in your car. The GO shouldn't block or interfere with any of the
following:
Your view of the road.

The controls in your car.

Your rear-view mirrors.

The airbags.

You should be able to reach your GO easily without leaning or stretching. You can attach your GO to
the windscreen or side window or you can use a Dashboard Mount Disk to attach the mount to your
dashboard.

Switching on and off

Switching your device on
Press the On/Off button until your device starts. If the device was off you see the map view. If your
device was sleeping you see the last screen you were looking at.
Sending your device to sleep
To send your navigation device to sleep, press the On/Off button and then release it.
You can also press the On/Off button for more than 2 seconds until you see the Sleep and Turn Off
buttons. Select Sleep to make the device sleep.
8