Sony DMP-1000P Service Manual page 18

Phase adjusting of Feeder cam Assy
1) Remove each part in numerical order in the figure.
(Refer to Fig.2)
1 Two screws
2) Rotate the gear (A) 8 in the direction of arrow, and pierce the
Pin (ø1) 9 through from a positioning hole on the reinforce-
ment to the feeder cam (L) Assy. (Refer to Fig.3)
3) Pierce the Pin (ø1) 0 though a positioning hole on the side
plate (R) in the state of step 2), then install the feeder cam (R)
Assy 7. (Refer to Fig.3)
4) Pull out the two Pins (ø1) 9 and 0, then install each part 1
to 6 in reverse order of removing. (Refer to Fig.2)
9 Pin (ø1)
8 Gear (A)
3 Tension spring
2 Feeder motor Assy
Fig.2
Reinforcement
FIg.3
2-6 E
4 Feed lock
Feeder cam (L) Assy
7 Feeder cam (R) Assy
Side plate (R)
6 Feed lock
5 Tension spring
7 Feeder cam (R) Assy
Positioning hole
0 Pin (ø1)