Aquacal Heat Pump Installation Manual page 32

INSTALLER-SPECIFIC TABLE of CONTENTS
INSTALLATION INSTRUCTIONS (continued):
Electrical Requirements ------------------------------------------- 44
General Requirements ------------------------------------------ 44
Code-Specific Requirements ----------------------------------- 44
Connecting External Controllers -------------------------------- 44
Sizing the Electrical Service ------------------------------------ 45
Ground Fault Protection (not recommended) ------------------ 45
CONTROLS CONFIGURATION & ADJUSTMENTS ---------------------- 46
Level-2 (dealer-service) Programming ---------------------------- 46
1. Entering Service Menu --------------------------------------- 46
2. Time Delay --------------------------------------------------- 47
3. Configuring for External Controllers ------------------------- 47
4. Water Sensor Calibration ------------------------------------ 47
5. Defrost Sensor Calibration ----------------------------------- 48
6. Spa Dead Band Differential (and adjustment) -------------- 49
7. Pool Dead Band Differential (and adjustment) ------------- 49
8. Changing Service Lock Code & "Back Door" Entry ---------- 50
Level-2 Set Up & Calibration Codes ------------------------------- 51
Factory Default Settings ------------------------------------------- 51
Troubleshooting Using Displayed Codes -------------------------- 52
Mode Jumper and Positioning ------------------------------------- 53
Defrost Systems (described and explained) ---------------------- 55
Water Flow Pressure Switch Adjustment-------------------------- 56
CONTACTING THE FACTORY ------------------------------------------ 58
32
(CONTINUED)