Desa Flame-Max VYM27NR Owner's Operation And Installation Manual page 17

INSTALLING LOGS
WARNING: Failure to position
the parts in accordance with these
diagrams or failure to use only
parts specifically approved with
this heater may result in property
damage or personal injury.
CAUTION: After installa-
tion and periodically thereafter,
check to ensure that no flame
comes in contact with any log.
With the heater set to High, check
to see if flames contact any log. If
so, reposition logs according to
the log installation instructions
in this manual. Flames contact-
ing logs will create soot.
It is very important to install the logs exactly
as instructed. Do not modify logs. Only use
logs supplied with heater.
1. Place bottom log (#1) on grate to fit as
illustrated in Figure 18. Make sure open
areas of logs line up with burner ports
(see Figure 19). Logs will fit securely on
chassis. IMPORTANT: Make sure log
does not cover any burner ports.
2. Facing front of unit, place top log (#2)
omto the pegs in the center of the bottom
log as illustrated in Figure 20.
Grate
Chassis
Figure 18 - Installing Bottom Log (#1)
121353-01F
INSTALLATION
Continued
Bottom Log (#1)
Burner Port
Burner
www.desatech.com
3. Position log piece (#3) by aligning holes
on underside with remaining pegs on bot-
tom log as illustrated in Figure 21. Do not
block burner ports.
4. Place lava rock around base of heater if
desired.
Burner Ports
Figure 19 - Installing Log set (Top View)
Peg
Figure 20 - Installing Top Log(#2)
Peg
Figure 21 - Installing Log Piece (#3)
Logs
Top Log
(#2)
Log Piece (#3)
17