Baumatic BYDI630 User Manual page 38

The dishes were not
loaded correctly.
The program was not
powerful enough.
Not enough detergent was
dispensed.
The dishes are
Items are blocking the
not clean.
path of the spray arms.
The filter combination in
the base of the wash
cabinet is not clean or is
not correctly fitted. This
may cause the spray arm
jets to get blocked.
Cloudiness on Combination of soft water
glassware. and too much detergent.
Black or grey Aluminium utensils have
marks on rubbed against dishes.
dishes.
Detergent left in Dishes blocking detergent
dispenser cups. cups.
Improper loading.
Too little rinse-aid.
Dishes are removed too
soon.
The dishes are
not drying.
Wrong program has been
selected.
Use of cutlery with a low
quality coating.
Unsatisfactory washing results
See "Loading the dishwasher baskets"
section.
Select a more intensive program. See the
"wash cycle table".
Use more detergent or change your
detergent.
Rearrange the items so that the spray can
rotate freely.
Clean and/or fit the filter combination
correctly.
Clean the spray arm jets. See the
"Cleaning the spray arms" section.
Use less detergent if you have soft water
and select a shorter cycle to wash the
glassware and to get them clean.
Use a mild abrasive cleaner to eliminate
those marks.
Reload the dishes properly.
Unsatisfactory drying results
Load the dishwasher as suggested in the
directions.
Increase the amount of rinse aid / refill
the rinse aid dispenser.
Do not empty your dishwasher
immediately after washing. Open the door
slightly so that the steam can escape.
Begin unloading the dishwasher only once
the dishes are barely warm to the touch.
Empty the lower basket first. This
prevents water from dropping off dishes in
the upper basket.
In short programs the washing
temperature is lower. This also lowers the
cleaning performance. Choose a program
with a long washing time.
Water drainage is more difficult with these
items. Cutlery or dishes of this type are
not suitable for washing in the
dishwasher.
39