Getting Started; Remote Control Code - Panasonic SC-HC05 Owner's Manual

Getting started

Remote control
Before using
Remove the insulation sheet before you use the remote control for the
first time.
Replacing the battery
Replace the remote control battery when it stops operating or when the
range is decreased. Replace with a new battery (CR2025) only.
Stopper
1
While pressing the stopper, pull out the battery holder.
2
Insert a new battery with the (+) side facing up.
3
Push the battery holder back fully.
CAUTION!
• Insert with poles aligned.
• Do not touch the terminals (+ and –) with metal objects.
• Do not recharge, disassemble, remodel, heat or throw into fire.
• Keep out of reach of children.
• Do not heat or expose to flame.
• Do not leave the battery(ies) in an automobile exposed to direct
sunlight for a long period of time with doors and windows closed.
• Remove the battery if you do not use the remote control for a long
period of time. Keep in a cool, dark area.
If any electrolyte should come into contact with your hands or clothes,
wash it off thoroughly with water.
If any electrolyte should come into contact with your eyes, never rub
the eyes.
Rinse eyes thoroughly with water, and then consult a doctor.
4
4
HC05_PC_us.indd 4 HC05_PC_us.indd 4
Insulation sheet
Connect the AC power supply cord
Rear view
To household AC outlet
• Use the included AC power supply cord with this system only.
• Do not use an AC power supply cord from other equipment.
Conserving power
The system consumes approximately 0.05 W when it is in standby
mode. Disconnect the power supply if you do not use the system.
Some settings will be lost after you disconnect the system. You have to
set them again.
Speakers
• Do not remove the speaker nets.
• These speakers do not have magnetic shielding. Do not put them
near TVs, PCs or other devices easily influenced by magnetism.
• When you play at high levels for a long period, it can cause damage
to the system and decrease the life of the system.
• Decrease the volume when you play distorted sound to prevent
damage.

Remote control code

When other Panasonic equipment responds to the remote control of
this system, change the remote control code for this system.
To set the code to "2"
Press and hold [MUTE] and [ R ] for a minimum of 4 seconds.
The green status indicator blinks 10 times.
To set the code to "1"
Press and hold [MUTE] and [ T ] for a minimum of 4 seconds.
The green status indicator blinks 10 times.
1/5/2011 12:16:54 PM 1/5/2011 12:16:54 PM