Multi-Feed Detection Options - Kodak i600 Series Image Processing Manual

Timeout
Power Saver
Multi-feed Detection
options
4-10
On — enable this option to set the amount of time the scanner will wait
after the last document enters the transport before the transport timeout
action is taken. You can specify a time delay setting from 1 to 300
seconds.
Response — allows you to specify the action that will be taken when
the transport timeout has been reached.
• End Job: stops the feeder and the transport but leaves the scanner
enabled. Scanning may be resumed by touching the Scan button on
the touchscreen.
• Stops Feeder and Transport: stops the feeder and the transport
and disables the scanner.
The Power Saver option allows you to set the amount of time the
scanner will remain inactive before the scanner goes into an idle state.
Choices are: 5 to 60 minutes; or Off.
Multifeed detection aids in document processing by detecting
documents that may go through the feeder overlapped. Multi-feeds can
happen due to stapled documents, adhesives on documents, or
electrostatically charged documents. Multi-feed Detection combines
ultrasonics (amplitude and phase) with physical length detection to help
eliminate the chance of loosing data due to multi-feeds.
Length Detection  if you enable this option, select the minimum
length of the document that can be scanned with a multi-feed being
detected. A value of 0 indicates no length detection. Length detection
can be used when scanning same-size documents. The maximum
value is 34.5 inches.
• Auto Set: automatically sets the maximum length value to .50-inch
(1.27 cm) greater than the length of the currently selected page size.
Ultrasonic Detection — check this option to set multi-feed detection.
Sensitivity — controls how aggressively the scanner will work to
determine if more than one document is fed into the transport. Multi-
feeds are triggered by detecting air gaps between documents. This
allows multi-feed detection to be used with job sets containing
documents with mixed thicknesses. You may set the Multi-Feed
Detection to Low, Medium or High sensitivity. When determining the
appropriate setting for your workflow, you should start at the Medium
sensitivity. If you select None, no multifeed detection will occur.
NOTE: Regardless of the setting, Post-It™ notes will be detected as
multi-fed documents.
A-61504 April 2007