Assigning An Ip Address To The Autodesk Control Surface - IBM Z PRO 6223 Hardware Setup Manual

3 Connecting System Components
If you are using only one panel, you can connect that panel directly to the workstation,
instead of using the switch.
Autodesk Control Surface
If you are using more than one panel, use network cables to connect each of the panels to the
3.
network switch.
4. If you are using the panel that includes the tablet, use a USB cable and extender to connect
the panel to a USB port on the back of your workstation.

Assigning an IP Address to the Autodesk Control Surface

After you have connected the Autodesk control surface, you must assign it an IP address.
28
To tablet connection
on Control Surface
panel
5V DC 4A
+ -
Windows- or Linux-Based
IBM IntelliStation Z Pro 6223
3 2
1
Autodesk
Tablet
Ethernet
1 0
8