Icom IC-F9511T User Manual page 45

■ Individual call ■ Individual call
Transmitting
Individual call allows you to make a call to a specific
station, and it provides private communication.
[Individual] key assignment is necessary to transmit
the Individual call.
1 Push [Individual] to enter the Individual ID 1 Push [Individual] to enter the Individual ID
selection mode.
• A pre-programmed ID name is displayed.
• When the ID name is not programmed, the ID
code is displayed.
• Push again to cancel and return to normal
operation.
2Select the desired Individual ID (or name) using
[CH Up]/[CH Down] or [CH Up/Down].
• The Individual ID can be edited with the
10- keypad*. (Depending on the pre-set value.)
*10-key models only.
▒ To edit the Individual ID using the 10-keypad:
▒ Input the Individual ID directly with the 10-keypad.
▒ • Push [ ] to clear a code.
▒
▒
▒
▒ ▒
3 Push and hold [PTT] to transmit the Individual call
to the target station, then speak into the
microphone.
• The Transmit indicator lights red.
• Depending on the pre-set value, the target station
does not open the squelch, and communication
is not established, if the Individual ID or NAC
(Network Access Code) is not matched.
4Release [PTT] to receive.
APCO P25 Mode Operation
Receiving Receiving
1 When an Individual call is received;
• The Busy indicator lights green.
• The ringer sounds. (Depending on the pre-
setting.)
• The calling station ID (or name) is displayed for
2 sec. (Depending on the pre-set value.)
• Depending on the pre-set value, the transceiver
d does not open the squelch, and communication
is not established, if the Individual ID or NAC
(Network Access Code) is not matched.
The calling station name ( or ID )
2 Push and hold [PTT] and speak into the
microphone.
3 Release [PTT] to receive a response.
▒ For P25 Trunking mode operation:
▒ When the Full Off Air Call SetUp (FOACSU) function ▒ When the Full Off Air Call SetUp (FOACSU) function
▒ is turned ON, beeps sound after receiving a call. In
▒ that case, push [PTT] to accept the call. Then,
▒ operate as described in steps ② and ③ above. If
▒ you ignore the call by not pushing [PTT] for a
▒ specified time period*, communication is not
▒ established. Or, pushing [Home] after receiving the
▒ call will also ignore it.
■ Talkgroup call
Transmitting
A Talkgroup call allows you to make a call to a
specific group only. [Talkgroup] key assignment is
necessary to transmit the Talkgroup call.
✔ For Trunking mode operation:
The [Talkgroup] key is not usable while in the
Trunking mode. To make a Talkgroup call, the group
affiliation should be performed with the desired
Talkgroup ID to call.
1 Push [Talkgroup] to enter the Talkgroup ID
(or name) selection mode.
• A pre-programmed ID name is displayed.
• When the ID name is not programmed, the ID
code is displayed.
• Push again to cancel and return to normal
operation.
t th l h d
g p
i ti
45