Installation; Hardware Installation - D-Link DCS-3511 User Manual

Hd poe and wireless network camera

Hide thumbs Also See for DCS-3511:

Table of Contents

Installation

Basic Connection (without PoE)

Connect the camera to your switch or router via Ethernet cable.

Connect the supplied power cable from the camera to a power outlet.

Connection Using a PoE Switch

If using a PoE switch or router, connect the network camera via Ethernet cable.

PoE will transmit both power and data over a single cable.

Note: Once power has been established, the LED will turn red. When the device

has obtained an IP address and is accessible, the LED will turn green.

Attach the Antennas (DCS-3530 only)

Locate the antenna included with your DCS-3530 and attach it to the antenna

connector located on the back of the DCS-3530.

D-Link DCS-3511/DCS-3530 User Manual

Table of Contents

Dcs-3530