Picture Frame/Computer Communications - Kodak Digital Photo Frame Extended User Manual

Resetting the clock after losing power
If you turn off the power on the frame or otherwise lose power for half a day or more,
the clock time returns to the factory setting and the automatic on/off times, if set, are
disabled.
When you turn the frame back on, the set time screen appears on the frame.
Slide to set the hour. Tap the left/right arrows to highlight the previous or next
setting (hour and minutes), then slide to adjust the setting.
Tap OK.
The Home screen appears. The time is reset and the automatic on/off times (if set) are
re-enabled. It is not necessary to reset the on/off times.
NOTE: If you exit the set time screen without setting the time, you can manually reset the clock and
re-enable the automatic on/off times (see

Picture frame/computer communications

If...
Cannot copy pictures to my
computer.
Cannot see my frame as a
removable drive.
Cannot copy pictures from
KODAK EASYSHARE
Software.
www.kodak.com/go/support
page 58). It is not necessary to reset the on/off times.
Try one or more of the following
Make sure your frame and computer are on.
Make sure to install the software that was packaged with
your frame (see
frame and computer using the EASYSHARE Digital Display
Software (page
Make sure the USB cable is securely connected
Make sure the power button on the frame is On
Make sure your frame and computer are on.
Make sure the USB cable is securely connected
Make sure to install the software that was packaged with
your frame (page
From My Collection in EASYSHARE Software, make sure the
pictures are in the Picture Tray.
Troubleshooting and support
page 8) and copy pictures between your
44).
8).
(page 26).
(page ii).
(page 26).
66