Dometic DS 200 Service Manual page 23

- Place drain water evaporator onto fluid heat-exchange pipe, making sure that
the end of the drain water outlet pipe reaches in the drain water evaporator.
(Fig. 76, 77)
Figure 76
- Secure aggregate with screws.
- Install heating element, boiler insulation, according to 2.3.2.2.3
- Push together thermal fuse – heating element electrical connection
- Push PCB connection of thermal fuse onto Fuzzy III panel
- Snap Fuzzy III panel back into base board, making sure that the positioning
pin of the base board fits into the bore of the panel (Fig. 78)
Figure 78
- Reinsert electrical cover, foot-frame, aggregate unit casing, secure with
screws (see 2.3.2.2., 2.2.1.)
- Place refrigerator in upright position
Figure 77
23