Standards And Approvals - Epson SC-P600 series User Manual

SC-P600 Series User's Guide
Network
Wired Standard:
LAN
*: IEEE802.11n is not supported.
Ink Specifications
Type Special ink cartridges
Pigment ink Black: Photo Black, Matte Black,
Light Black, Light Light Black
Color: Yellow, Cyan, Light Cyan,
Vivid Magenta, Vivid Light Magenta
Use by date See the date printed on the
package and cartridge (at normal
temperature)
Print quality Six months (after opening the
guarantee expiry package)
Storage Uninstalled:
temperature -20 to 40°C (within a month at 40°C)
Installed:
-20 to 40°C (within a month at 40°C)
c
Important:
❏ The ink freezes if left at below -15°C for a long
time. If the ink does freeze, leave it at room
temperature (25°C, no condensation) for at
least three hours before use.
❏ Do not refill the ink.
Supported operating systems
Windows Vista/Windows Vista x64
Windows 7/Windows 7 x64
Windows 8/Windows 8 x64
Windows 8.1/Windows 8.1 x64
Mac OS X 10.6.8/10.7.x/10.8.x/10.9.x

Standards and Approvals

U.S. model:
Safety UL60950-1
CAN/CSA-C22.2 No.60950-1
EMC FCC Part 15 Subpart B Class B
CAN/CSA-CEI/IEC CISPR 22 Class B (CAN
ICES-3(B) / NMB-3(B))
Appendix
Ethernet 100BASE-TX/10
BASE-T
This equipment contains the following wireless module.
- Manufacturer: ASKEY Computer Corp.
- Type: WLU6117-D69 (WLU6117-D69 (RoHS))
This product conforms to Part 15 of the FCC Rules and
RSS-210 of the IC Rules.
Epson cannot accept responsibility for any failure to
satisfy the protection requirements resulting from a
non-recommended modification of the product.
To prevent radio interference to the licensed service,
this device is intended to be operated indoors and away
from windows to provide maximum shielding.
Equipment (or its transmit antenna) that is installed
outdoors is subject to licensing.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:(1)
This device may not cause harmful interference, and (2)
this device must accept any interference received,
including interference that may cause undesired
operation.
This device complies with Industry Canada
licence-exempt RSS standard(s). Operation is subject to
the following two conditions:(1) this device may not
cause interference, and (2) this device must accept any
interference, including interference that may cause
undesired operation of the device.
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and
receiver.
- Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
118