Table of Contents
Advertisement
TROUBLESHOOTING CHART:
THE PROBLEM
Won't toast...
Toasts unevenly... d. Only part of product surface is
Product sticks to
conveyor or slide..
No power...
Won't heat...
Lighter toast
Under peak loads. r. Very moist product.
Conveyor won't
move...
THE CAUSE
a. Toaster cold.
b. Wrong power switch position.
c. Wrong conveyor speed setting.
Toasted.
e. Product located too far to side of
conveyor.
f. Butter or butter substitute used on
product.
g. Conveyor surface has baked-on oil g. Follow daily cleaning methods to
residue.
h. Very moist or doughy product.
i. Product not defrosted or thawed.
j. No power to receptacle.
k. Toaster unplugged.
I. Loose connections.
m. Power switch.
n. Loose connections.
o. Faulty power switch.
p. Burnt out element.
q. Speed control setting.
s. Product too cold.
t. Toaster cavity temperature being
quenched.
u. No power.
v. Conveyor links are binding.
w. Drive chain too loose or too
tight.
x. Loose or bad connection
between speed control and
conveyor motor.
y. Conveyor motor burnt out.
z. Speed control burnt out.
THE SOLUTION
a. Allow five (5) minutes for warm up.
b. Position power switch to full power.
c. Reduce conveyor speed.
d. Reduce conveyor speed.
e. Place product on conveyor between
end links.
f.
Discontinue use of butter or butter
substitute.
remove & prevent residue.
h. Use different source or day-old
product.
i.
Defrost/thaw product.
j.
Check circuit breaker.
k. Plug in toaster.
I.
Check connections.
m. Check that switch is on &
operational.
n. Check connections.
o. Replace power switch.
p. Replace element.
q. Reduce speed control setting.
r.
Use different source or day old
product.
s. Allow product to warm to room
temperature.
t.
Add 1" or more spacing between
product.
u. Check circuit breaker.
v. Check conveyor for bent links.
w. Adjust drive chain.
x. Check for loose or bad
connection.
y. Replace conveyor motor.
z. Replace speed control.
7
Advertisement
Table of Contents
