Installation Procedures
If the GNS 480 is setup to IGNORE the CDI select key and discrete input (refer to
3.2.1.6) this input will not be functional.
2.8.9.2
COM Flip-Flop Switch
P1-14
COM Flip Flop In
The COM Flip Flop In is used to toggle the active and standby COM frequencies. A momentary ground
on this input performs the same function as pressing the COM flip-flop soft key (↔) on the bezel.
2.8.9.3
VOR Flip-Flop Switch
P1-34
VOR Flip Flop In
The VOR Flip Flop In is used to toggle the active and standby VOR/LOC frequencies. A momentary
ground on this input performs the same function as pressing the VOR flip-flop soft key (↔) on the bezel.
2.8.9.4
Push to Talk (PTT)
P4-4
PTT
The PTT is used to transmit on the COM radio. A ground on this input enables the COM MIC audio and
causes the COM transceiver to transmit on the active frequency.
2-32
NOTE
560-0982-01 Rev L
GNS 480 (CNX80) Installation Manual