Connections; Output Side Connections - Technics SH-MZ1200 Operating Instructions Manual

Connections

Output side connections

Connect the various equipment to the DJ mixer using stereo phono cables, connection cables and appropriate cables (Each sold separately).
When connecting, make sure to turn all equipment power off.
Stereo phono cables
Speakers
(Not included)
Amplifier
(Not included)
Connect when using an amplifier that
has XLR terminals. Terminal polarity is
indicated in the diagram below.
Ground
Cold (–)
Amplifier
(Not included)
(XLR terminal
compatible)
Speakers
(Not included)
Connection to the XLR terminals
•Open the terminal cover, align the polarities on the XLR plug (not
included) and XLR terminal and insert the plug until it locks.
•To remove the XLR plug, press the knob
and remove it.
•After removing it, press the center of the terminal cover and close
firmly.
When using a monaural input effector
•Connect to the R/MONO terminal.
•The mixed left (L) and right (R) signal is output to the effector, and the left (L) and right (R) signal from the effector is input.
When listening with headphones
•Turn down the volume using the MONITOR LEVEL control knob before connecting.
•Avoid listening for prolonged periods of time to prevent hearing damage.
White (L)
Red (R)
Speakers
(Not included)
Amplifier
(Not included)
Hot (+)
Cassette deck (Not included)
on the top of the plug
Speakers
(Not included)
Monitor amplifier
(Not included)
Connection
cable
(Not included)
Type:
RCA coaxial
AV Control Receiver Effector (Not included)
(Not included) Connect if you want to use an
external effector or sampler etc.
to adjust the sound.
Rear panel
Type:
6.3 mm
monaural
Front panel
Type:
6.3 mm stereo
Headphone
(Not included)
7
RQT7231