Fader Start Function; Start Using The Channel Fader; Start Using The Cross Fader - Technics SH-MZ1200 Operating Instructions Manual

Fader start function

You can start music play from the SL-DZ1200 direct drive digital turntable (not included) using the channel fader and cross fader by connecting the
digital turntables to CH1 and CH4. (A control cable is necessary for this connection.
Before use
•Turn [MODE] to TURNTABLE on the rear panel of the digital
turntables connected to CH1 and CH4.
•Set the auto cue point and cue point on the digital turntables
connected to CH1 and CH4, and standby at the set point.

Start using the channel fader

When the digital turntable you want to control is connected to CH1
and the channel fader operation switch is set to NORMAL.
•When individually adjusting the left (L) and right (R) input (
12), perform the following instructions simultaneously for the CH1
and CH2 channel faders on the panel.
1
Turn [ASSIGN A] and select any number
other than 1
•The channel fader will not start the digital turntable if 1 is
selected.
2
Push the channel fader all the way to
zero
3
Switch [FADER START (CH1)] to ON
4
Push the channel fader up when you
want to start play
•Play instantly begins from the digital turntable.
If you push the channel fader back to the original position (zero) after
play on the digital turntable has started, the digital turntable returns to
the set point and waits in the standby position.
page 8)

Start using the cross fader

When the digital turntable you want to control is connected to CH1
and the cross fader operation switch is set to NORMAL.
1
Turn [ASSIGN A] and select 1
2
Push [CROSS FADER] all the way in the
direction opposite the source you want
to start ( )
3
Switch [FADER START (CH1)] to ON
4
Slide [CROSS FADER] in the direction
opposite of instruction 2 when you want
to start play
•Play instantly begins from the digital turntable.
If you push the cross fader back to the original position after play on
the digital turntable has started, the digital turntable returns to the set
point and waits in the standby position.
Alternate play of two digital turntables connected to CH1
and CH4
When the cross fader operation switch is set to NORMAL.
1
Turn [ASSIGN A] to select 1 and turn
[ASSIGN B] to select 4
2
Push [CROSS FADER] all the way in the
direction opposite the source you want
to start ( )
3
Switch [FADER START (CH1)] and
page
[FADER START (CH4)] to ON
4
Push [CROSS FADER] all the way in the
direction opposite of instruction 2
(towards
play
•Play instantly begins from the digital turntable connected to
CH1. (At the same time, the digital turntable returns to the
set point when playing on CH4)
5
Push [CROSS FADER] all the way in the
direction opposite of instruction 4
(towards
•Play instantly begins from digital turntable on CH4.
•Play on CH1 instantly returns to the set point.
Note
While you are using the fader to start play, turning the unit off and on
may stop or start the digital turntable.
), when you want to start
)
13
RQT7231