Connecting To A Macintosh Computer - Kodak DC240 User Manual

Connecting to a Macintosh Computer

Either a serial cable for a Maintosh computer or adapter plug for use with
the RS-232 serial cable is provided so you can connect your camera
through a serial port on a Macintosh computer.
1
Set the Mode dial to Connect.
2
Connect the serial port adapter plug into
the 9-pin end of the serial cable.
3
Plug the adapter end of the serial cable
into an available serial port on the back of
the computer.
If your camera came with a serial cable for
a Macintosh computer instead of the
serial adapter plug, connect the end of the
serial cable labelled MAC into the
available serial port on the back of the
computer.
Serial ports on Macintosh computers are
usually referred to as modem or
printer ports.
If the ports are not labeled, see your
computer User's Guide for a diagram that
illustrates all of the external ports.
4
Open the serial/USB port door on the
side of the camera.
5
Plug the other end of the serial cable into
the camera serial port.
6
Slide the POWER switch to the right to
turn on the camera.
If you get a message on your computer
stating that you are not connected, refer to
the Connect.PDF document installed with
the software, or the online help for
troubleshooting information.
7
63