Kodak DIGITAL SCIENCE DC200 User Manual page 71

DC200/DC210 Camera
Problem
Ready light does not turn on
and the camera does not work.
Shutter button does not work.
Camera does not turn on.
Cause
Batteries are low or
empty.
Camera is not turned
on.
Camera is not turned
on.
Mode dial is not set to
Capture.
Ready light is
blinking. Camera is
processing picture.
The Status Display
reads Full. The
memory card is full.
Camera is connected
to the computer.
Batteries are not
properly installed.
Batteries are weak or
dead.
Solution
Replace the batteries.
Pictures remain in the
camera's memory
when the battery is
removed.
Turn the camera on
and verify that the
green Ready light
turns on.
Turn the camera on
and verify that the
green Ready light
turns on.
Set the Mode dial to
Capture.
Wait until Ready light
stops blinking before
attempting to take
another picture.
Transfer pictures to
your computer or
insert a memory card
that has available
memory.
Disconnect camera
from computer.
Remove the batteries
and install them
according to the
directions on the
outside of the battery
door.
Install new batteries.
9-5
9