Using The Mirror Lock-Up With The Remote Controller; Replacing The Remote Controller Battery - Kodak 6B8773 User Manual

Using the Mirror Lock-Up
with the Remote Controller
Replacing the Remote
Controller Battery
April 28, 2004
When using Mirror Lock-Up mode with the Remote Controller, use either
AF or Manual focus to set the lens focus for the scene, then switch the lens
to the MF position. If the lens is left in AF, the camera performs an
autofocus when it receives the signal from the Remote Controller, and you
will not be able to verify the correct focus.
1. Rotate the D-Dial to UP.
2. Set the camera to Remote Control mode.
3. Lightly press the Shutter button to set the focus, then set the lens
switch to MF.
4. Aim the Remote Controller at the camera's Remote Control sensor and
press the Transmit button.
After a fixed time interval, the image is captured and the mirror
returns home. See
interval of the Mirror Prerelease function.
Use two CR 1220 3V Lithium coin type batteries.
1. Remove the bottom cover screws with a screwdriver.
2. Open the bottom cover and replace the batteries.
3. Replace the cover and tighten the screws. Be careful not to
over-tighten.
Check the Remote Controller operation after replacing the batteries.
Configuring your Camera
page 5-3 for information on setting the time
5-29