Installation Precautions; Other Precautions - Kyocera FS-C8500DN Operation Manual

xvi
Downloaded From ManualsPrinter.com Manuals

Installation Precautions

Environment
CAUTION Avoid placing the printer on or in locations which
are unstable or not level. Such locations may cause the
printer to fall. This type of situation presents a danger of
personal injury or damage to the printer.
Avoid locations with humidity or dust and dirt. If dust or dirt
becomes attached to the power plug, clean the plug to avoid
the danger of fire or electrical shock.
Avoid locations near radiators, heaters, or other heat
sources, or locations near flammable items, to avoid the
danger of fire.
To keep the printer cool and facilitate changing of parts and
maintenance, allow access space as shown below. Leave
adequate space, especially around the side cover, to allow
air to be properly ventilated from the printer.
Left: 300 mm Right: 300 mm
(11-13/16 inches) (11-13/16 inches)

Other Precautions

The service environmental conditions are as follows:
- Temperature: 50 to 90.5 °F (10 to 32.5 °C), but humidity should be
70% or less when temperature is 90.5 °F (32.5 °C)
- Humidity: 15 to 80%, but temperature should be 86 °F or less (30 °C
or less) when humidity is 80%
However, adverse environmental conditions may affect the image quality.
It is recommended to use the printer at a temperature: around 60.8 to
80.6 °F or less (16 to 27 °C), humidity: around 36 to 65%. In addition,
Avoid the following locations when selecting a site for the printer.
- The printer automatically detects and displays the following message
when the environmental temperature is too high or too low.
Message: High temperature. / Adjust room temp. or Low
temperature. / Adjust room temp..
To use the printer under optimum conditions, adjust the temperature and
the humidity of your room if the message is displayed.
- Avoid locations near a window or with exposure to direct sunlight.
- Avoid locations with vibrations.
- Avoid locations with drastic temperature fluctuations.
Top: 400 mm
(16 inches)
Rear: 100 mm
(3-15/16 inches)
Front: 1,000 mm
(39-3/8 inches)