Behringer TUBE ULTRAGAIN MIC200  User Manual page 5

TUBE ULTRAGAIN MIC200
It should light up only at peak signals, but it should never be on
all the time.
If your MIC200 is connected to the mains via the enclosed
power supply unit, the POWER LED lights up to indicate that
your MIC200 is running.
The 20 dB PAD switch reduces the input sensitivity by 20 dB
(switch pressed). The appropriate setting depends on the
equipment connected. Generally speaking, lowering the signal
level in mic applications is not recommended. No matter what
your application is, the clip LED warns you to reduce the gain
setting to avoid distortion.
This +48 V switch activates the phantom power supply for the
XLR input. Phantom power supply is required for operating
condenser microphones. Dynamic microphones require no
phantom power.
Press the LOW CUT switch to eliminate undesired subsonic
noise, such as floor rumble.
With the PHASE REVERSE switch, the input signal is reversed
by 180°. This function is available for both mic and line signals.
Use this function in a multi-microphone setup if you detect
phase cancellations in specific frequency bands.
The OUTPUT control governs the output level within a range
from -oo to +10 dB. If the control is turned all the way to the left,
there is no output signal at all. The more the control is turned to
the right, the higher the output level.
The PREAMP MODE rotary switch gives you a wide selection
of preamp presets. The options available are: WARM, WARM/
LIMITER, LIMITER and NEUTRAL:
5
2. CONTROL ELEMENTS