Direct printing (PICTBRIDGE enabled printer) problems
Status
Cannot print to a
PICTBRIDGE Printer
Picture quality problems
Status
Picture is not clear
Picture is too dark
www.kodak.com/go/support
Solution
■
In the Setup menu, change the Computer Connection setting to
Other Application
Solution
■
To automatically set exposure and focus, press the Shutter button
halfway. When the framing marks turn green, press the Shutter
button completely down to take the picture.
■
Clean the lens
(see page
■
Make sure the camera is not in Macro mode if you are more than
27.6 in. (70 cm) from your subject
■
Place the camera on a flat, steady surface or use a tripod (especially
in high-zoom settings or in low light).
■
Use a larger picture size
■
If you're manually adjusting the ISO speed, realize that high ISO
setting may cause grainy pictures
■
Reposition the camera for more available light.
■
Use Fill flash
(see page
or change your position so light is not behind the subject.
■
Move so that the distance between you and the subject is within the
effective flash range. (See
■
To automatically set exposure and focus, press the Shutter button
halfway. When the framing marks turn green, press the Shutter
button completely down to take the picture.
■
In Program mode, increase the Exposure Compensation
page
31).
(see page
34).
46).
(see page
(see page
30).
(see page
8) in Program mode, Backlight in SCN mode,
Specifications, page
Troubleshooting
32).
31).
44.)
(see
42