Pioneer AVH-X7700BT/XNUC Service Manual page 34

1
Description of FLAP storage operation
A
(1) When CLOSE key is pressed or the automatic switching setting is turned ON, the motor for angle drive is rotated in 0°
direction in 6 seconds after ACC is set to ON. When the setback setting is turned ON, the motor for backward and
forward drive is rotated in ejection direction at high speed. If the status of analog signal of O/C/D SW changes from 5 to
4, the motor is continuously rotated for 600 ms, and then the motor for angle drive is rotated in 0° direction.
B
(2) After the status of analog signal of O/C/D SW changes from 4 to 3, the motor for angle drive is rotated in 0° direction for
900 ms and the pushing operation is carried out.
C
(3) In 900 ms, the motor for angle drive is braked and the motor for backward and forward drive is rotated in storage direction.
D
(4) If the status of analog signal of O/C/D SW changes from 2 to 6, the motor for backward and forward drive is rotated in
storage direction at low speed.
E
(5) In 700ms after the status of analog signal of O/C/D SW changes from 6 to 1, the motor is braked and the monitor
storage is completed.
F
34
1
2
AVH-X7700BT/XNUC
2
3
3
4
4