Safety Information; Warning Statements; Cautionary Statements - Kodak ESP 3200 Start Here Manual

Safety Information

Warning Statements

Cautionary Statements

10
• Read and follow these instructions before using KODAK Products.
• Always follow basic safety procedures.
• Follow all warnings and instructions marked on the equipment.
• Do not expose this product to liquid, moisture, or extreme temperatures.
KODAK AC Adapters are intended for indoor use only. The use of controls,
adjustments, or procedures other than those specified herein may result in
exposure to shock and/or electrical or mechanical hazards.
• Keep ink cartridges out of reach of children. Ink may be harmful if swallowed.
• Do not place your all-in-one printer on an unstable cart, stand, bracket, or table.
Injury to persons and damage to the equipment may occur.
• The use of an accessory attachment that is not recommended by Kodak, such as
an AC adapter, may cause fire, electric shock, or injury.
• Pushing objects through the equipment openings can result in an electric shock
or risk of fire.
• Adjust only those controls covered in the operating instructions.
• Do not disassemble this product; there are no user-serviceable parts inside.
Refer servicing to qualified service personnel.
• The AC adapter power supply is equipped with 3-wire grounding type plugs. If
you cannot insert the plug into the power outlet, contact an electrician to check
or replace the power outlet.
• Do not plug the AC adapter into a household extension cord.
• If the power cord or plug is frayed or damaged, the equipment gets wet, or the
equipment does not operate normally when the operating instructions are
followed, unplug your printer from the power outlet and contact Kodak at
www.kodak.com/go/contact
• For added protection from damage during a lightning storm, or any time when
your printer and its associated AC adapter will be left unused for long periods of
time, unplug the AC adapter from the power outlet and any attached fax line
from the printer.
• To prevent your printer from overheating, do not place it near a heat register, or
install it in a cabinet without proper ventilation.
• Do not use your printer near water or spill liquid on it.
• Unplug the equipment from the wall outlet before cleaning.
• Dropping your printer may damage the housing and result in extensive damage
that will require repair by a qualified technician to restore normal operation.
• Excessive dust levels may damage internal parts.
For more information, go to
www.kodak.com/go/aiosupport
for further instructions.
www.kodak.com/go/MSDS.