Utilisation And Maintenance Of The Water - Whirlpool Refrigerator Instructions For Use Manual

UTILISATION AND MAINTENANCE OF THE
WATER DISPENSER AND FILTER
Water dispenser
First use
The first time you use the water dispenser or after a long period left not used wash the tank and the
filter with water. The water dispenser provides fresh, filtered water, without the need of opening the
refrigerator door. This will reduce the number of times the door is opened, thus also reducing energy
consumption of the product.
Fitting and replacing the active carbon filter
The water filter should be removed from the foil bag (found in the crisper drawer (item 7). Follow the
instructions provided with the filter.
Important: If the filter is left dry for an extended period of time, its performance may be reduced.
Immerse the filter in water for a few seconds to reinstate optimum performance.
Water tank (fig. 1)
To fill the tank, rotate the cap
in the direction of the arrow
The water tank is made of antibacterial material. This prevents and reduces the
proliferation of bacteria.
An internal container, with an active carbon filtered ensures water filtration.
To fill the tank: rotate the water inlet towards you and fill with water, using a jug or
other suitable container. Once the tank is full, close the water inlet by moving it back to
Tank
its original position.
Fig. 1
Always use drinking water only: any other liquid may impair product performance.
Activation
device
Stop
Obtaining filtered water (fig. 2)
After filling the tank, the water may not be immediately available. This is because the
filtering process may require a few minutes (depending on the amount of water in the
Water
drip tray
tank).
Fig. 2
To dispense water: with the refrigerator door closed, press the water dispenser tab
with the glass.
If for safety reason water delivery must be prevented, simply press the stop at the
back of the tab. To release water delivery move the stop back to its original position.It
is recommended to drink the supplied water from the dispenser in 6 hours.
Cleaning the water tank (fig. 3-4-5-6-7-8-9)
Fig. 3
Periodically clean the water tank with running water. Twice a year it is recommended
to keep healthy the unit using specific products based on diluted chlorine that not
modify the material properties and rinse with current water.
To clean the tank, proceed as follows:
- (fig. 3) release and remove the top door tray
- (fig. 4) release and remove the water tank by lifting it and pulling towards you. Place
Fig. 4
Fig. 5
Fig. 6
Suggested exchange of filter for a standard consumption usage of:
3,0 l/day
Fig. 8 4,5 l/day
6,0 l/day
Filter replacement is not covered by product warranty. To order more water filter
cartridges, please contact your after-sales service.
Fig. 9
the tank on a flat surface, remove and wash the top cover.
Note: the tank must be refitted in its position as soon as
possible, to prevent the refrigerator from overheating.
- (fig. 5a -5b) remove the internal container and the filter, and wash
them separately. When washing the filter, only use clean water
(no detergent or sharp tools). To clean the disk filter, first remove it
from the container.
- (fig. 6) for a more thorough cleaning, remove the valve cap (the fitting
connecting the tank to the refrigerator) by rotating it anticlockwise.
Clean the cap. Important: do not pull on the valve body (fig. 7).
- (fig. 8) replace the valve cap by rotating clockwise.
- (fig. 9) fit the tank back in place by placing it between the lateral
Fig. 7
guides of the door and pushing it in position, ensuring that the valve
is back in its original seat. Check that the there are no gaps between
the rubber seal of the tank and the door.
4 months
3 months
2 months
7
(if present)