Power Connector; Electrical Connections - Panasonic CQ-VD7003U Installation Manual

Electrical Connections

Caution
¡This unit is designed for use in a car having a 12 V negative ground battery system.
¡Be sure to insulate any exposed wires from the car chassis. Bundle all cables and keep cable terminals free from
any metal parts.
13
¡Note that if your car has a driving computer or a navigation computer, disconnecting the cable from the battery
may clear the memory.
¡Run the cords avoiding the spots where the temperature can be extremely high.
Navi Mute Lead (Orange)
Connect to the Navi Mute Lead of the Panasonic car
navigation system. (available in future)
ANT-CONT MAX 0.1A
Motor Antenna Relay Control Lead (Blue)
(To motor antenna) (Max. 100 mA)
This lead is not intended for use with a switch actuated
power antenna.
Side Brake (Parking Brake) Connection Lead (Bright
green)
Be sure to wire the side brake (parking brake) for safety and
preventing accidents.
AMP-CONT MAX 0.1A
External Amplifier Control Power Lead (Blue/white stripe)
To an external amplifier.
Power Lead (Red)
To ACC power, +12 V DC.
Battery Lead (Yellow)
To the car battery, continuous +12 V DC.
BATTERY 15 A
(Fuse 15 A)
Ground Lead (Black)
To a clean, bare metallic part of the car chassis
14
CQ-VD7003U
NAVI MUTE
SIDE BRAKE
(a page 13)
ACC
Ω
(Resistor 1 k )
(Noise Filter)
!3

Power Connector

Front Right + (Gray)
Front Right – (Gray/black stripe)
FRONT SP
Front Left + (White)
Front Left – (White/black stripe)
Rear Right + (Violet)
Rear Right – (Violet/black stripe)
REAR SP
Rear Left + (Green)
Rear Left – (Green/black stripe)
Speaker connections
• Do not connect more than one speaker to one set of
speaker leads (except for connecting to a tweeter).
• Do not use a 3-wire type speaker system having a com-
mon earth lead.