General Installation - Kenmore Front Load Dryer Installation Instructions Manual

General installation

1 Connect the exhaust duct to the outside exhaust
system. Use of a 4" (102 mm) clamp (item A) is
recommended to connect the dryer to the exhaust
vent system. Use metal foil tape to seal all other
joints.
2 Carefully slide the dryer to its fi nal position. Adjust
one or more of the legs until the dryer is resting
solidly on all four legs. Place a level on top of the
dryer. The dryer MUST be level and resting solidly
on all four legs. Rock alternating corners to check
for stability. Remove and discard door tape.
IMPORTANT
Be sure the power is off at a circuit breaker/fuse box
before plugging the power cord into an outlet.
3 Plug the power cord into a grounded outlet.
Grounding type Grounding type
wall receptacl wa ll receptacle
Do not, Do not, under under
an any cir y circumstances, cumstances,
cut, remo cut, remove ve,
or b or bypass th ypass the
gr grounding pr ounding prong.
Po Power cord with wer cord with
3-prong 3-prong gr grounded plug ounded plug
4 Turn on the power at the circuit breaker/fuse box.
5 Read the Use & Care Guide provided with the dryer.
It contains valuable and helpful information that will
save you time and money.
6 If you have any questions during initial operation,
please review the "Avoid Service Checklist" in your
Use & Care Guide before calling for service.
7 Place these instructions in a location near the dryer
for future reference.
NOTE
A wiring diagram and technical data sheet are located
under the dryer top panel.
ong.
Installation Instructions
A
19