Installation In A Rack - Fujitsu ETERNUS DX200F Setup Manual

Installation in a Rack

STEP
The rack rail needs to be attached to the rack and the ETERNUS DX (controller enclosure) needs to be installed.
Configuration Guide (Basic)
The center of gravity must be taken into consideration to prevent a rack from toppling over. The controller
IMPORTANT
enclosure should generally be installed from bottom to top to lower the center of gravity and to ensure the safe
use of racks.
1.
Attach the rack rails to the rack.
The size of the controller enclosure is 2U.
Plate
M5 screws
(Front rack pillars)
2.
Install and fasten the controller enclosure in the rack.
M5 screws
Flange cover
IMPORTANT
Rack rail (for left side)
Washers
Plate
M5 screws
Rack rail (for right side)
M5 screws
Flange cover
Make sure to install or remove the controller enclosure to or from a rack with two or more people.
FUJITSU Storage ETERNUS DX200F All Flash Array Setup Guide
Copyright 2014 FUJITSU LIMITED
(Rear rack pillars)
M5 screws
M5 screws
Washers
2
P3AM-8482-01ENZ0