Problems After Initial Boot - HP ProLiant BL40p Setup And Installation Manual

Troubleshooting
6. Connect the server blade to system power using one of the following methods:
— Install the server blade in the enclosure.
— Connect the server blade to the diagnostic station.
7. Power up the server blade using one of the following methods:
— Press the Power On/Standby button on the front of the server blade.
— Use the virtual power button feature in the iLO remote console.
8. As soon as the server blade powers up, it emits two beeps.
9. Repeat steps 1 through 3.
10. Change positions 1, 5, and 6 of SW3 to off.
11. Repeat steps 5 through 7.
If both the current and backup versions of the ROM are corrupt, you must return the
system board for a service replacement. Refer to the HP ProLiant BL p-Class System
Maintenance and Service Guide and contact an authorized reseller.

Problems After Initial Boot

Once the server blade has passed POST, you may still encounter errors, such as an
inability to load the operating system. Reinstall the operating system and use the
documentation that ships on the Rapid Deployment Pack CD or refer to "Software
Problems" in the HP ProLiant Servers Troubleshooting Guide on the Documentation
CD for more information.
Refer to the HP ProLiant Servers Troubleshooting Guide on the Documentation CD
or to the HP reference library, accessed through
following:
•
Information you need to collect when diagnosing software problems and to
provide when contacting support
•
Instructions on how to upgrade the operating system and its drivers
•
Information about available recovery options and advice on minimizing
downtime
D-14
www.hp.com/support
HP ProLiant BL40p Server Blade Setup and Installation Guide
, for the