Delivery Tube; Vent And Fan Assembly - Frigidaire Fully Integrated Direct FeedModel Dishwashers Service Manual

The following repairs will require removing the
dishwasher from under the counter. Before starting
the repair, disconnect the power to the product, also
make sure others are aware that you have turned
this off for your safety. Turn off the water supply to
the dishwasher and mark the valve as being turned
off this is again for safety. After the utilities have
been turned off, lower the dishwasher as much as
possible to prevent damage to the counter. Always
use floor protection as the unit is pulled forward.

DELIVERY TUBE

1. With dishwasher removed from under counter
top unscrew and remove the upper spray arm.
This unscrews counter clockwise.
Figure 52
2. Remove mounting screw in back of tub. See
Figure 52
3. Remove clamp from sump end of tub and
remove tube.
4. Check hole in back of tub for
grommet to be sure it is
smooth and no extra plastic
around opening
5. Install gourmet from inside
tub, outside flange must be
flat on back of tub. See
Figure 53
outside flange
Figure 53
6. To install tube start by placing tube in top of tub
and installing upper spray arm loosely.
7. Place center opening of delivery tub into the tub.
Be sure to hold grommet in place while pressing
tube into opening.
8. Reinstall tube on to sump then install center
9. Tighten both upper spray arm mounting nut and

Vent and Fan Assembly

1. With the dishwasher removed from under the
mounting screw
tube
2. The locking collar holding the assembly in place
3. Installing new assembly be sure gasket is in
screw.
clamp on sump.
counter either remove the upper rack or just pull
forward to access the vent assembly
Vent and fan assembly mounting nut.
Figure 54
turns off to the left (counterclockwise). See
Figure 54
This is a very tight
fit pressing down
on the outside of
the assembly can
help in removing
part See Figure
55
place and collar locks on completely to prevent
leaks. See Figure 56
Figure 56
25
Figure 55