HP StorageWorks 1000ux Setup Manual page 21

The components listed in
needed for operation.
Table 4: Needed components
SCSI cables
Host Bus Adapter (HBA)
Power cord
Application software
HP StorageWorks 1000ux/1900ux/2300ux Optical Jukebox Setup Guide
Table 4 are not supplied with the jukebox, but are
Component Description
High-density 68-pin (Micro D) connector
for low-voltage differential interfaces
Low- voltage differential SCSI (LVDS)
with a free address for each drive in the
jukebox, plus one additional address.
For example, an HBA would need 5 free
addresses for a 4-drive jukebox.
Note: The HBA must be dedicated to the
jukebox and cannot be shared with
other devices.
A single-ended (SE) HBA can be used
with this LVDS device. However, to
ensure optimum performance, HP
recommends using an LVDS HBA to take
advantage of higher data transfer rates.
If an SE HBA is used, the maximum
cable length will be limited to 3 meters.
Note: If the jukebox is placed on a bus
with an SE peripheral, the bus will run in
SE mode even if the HBA is LVDS.
Localized power cord as required
Required to operate your jukebox.
Consult with your sales representative to
identify the software that best meets your
needs.
Installation
21