Disassembly
Removing and Replacing the Rear Housing
20
1.
Remove the battery cover, battery, SIM card and antenna as described in the
procedures.
Note: The antenna must be removed before the rear housing can be removed.
2.
Remove the 2 rubber screw covers and using a Torx
remove the 4 screws from the rear housing (see Figure 8).
3.
Using a small screwdriver, disengage the 2 side housing latches.
4.
Carefully separate the rear housing from the front housing and lift the rear
housing up and away from the front housing to remove.
4 Screw Locations
(Remove Antenna
Before Back Housing)
Rear Housing
Figure 8. Removing and Replacing the Rear Housing
5.
To replace, align the rear housing on the front housing and gently press the 2
housings together until the 2 side housing latches snap securely.
6.
Insert and torque the 4 screws to 2.6 in. pounds.
7.
Replace the 2 rubber screw covers over the top screws.
8.
Replace the antenna, Sim card, battery, and battery cover as described in the
procedures.
September 28, 2004
®
driver with a T-6 bit,
2 Housing Latches
Lift Rear Housing
Up and Off Front Housing
V551 GSM
6809490A38-O