Advertisement
Connecting to an Amplifier
The speaker's rated impedance is 6
you connect an amplifier that is compatible with a 6
impedance.
1. Before connecting the speakers, disconnect your
amplifier's power cord from the wall outlet and set its
volume control to minimum.
2. Connect the input terminals on the back of the
speakers and the speaker output terminal of your
amplifier with the speaker cables as shown below.
0 To connect the terminals correctly, identify which
terminals are for L (left channel) and R (right
channel) and which terminals and cables are +
(positive) and - (negative).
0 Speaker cables are not supplied with the speakers.
Speaker
R (right channel)
output terminal
speaker
of your
amplifier
Peel the
Loosen the
insulation off the
terminal screw and
ends of the
insert the speaker
speaker cable
cable into the hole
and twist the core
(until the core wires
wires.
are inserted fully).
3. Before turning on your amplifier, check the following
points:
0 Check carefully that the + (positive)
and - (negative) speaker cables are not
short-circuited (i.e., not touching each
other). Short-circuited cables may
cause damage to your amplifier.
0 Do not mix up + (positive), - (negative) and L (left
channel), R (right channel) of the speaker cables.
Doing so may weaken the bass sound, resulting in
unstable sound localization.
0 Pull the speaker cables lightly to check that they are
connected firmly.
h
. Make sure
h
L (left channel)
speaker
Fasten the terminal
screw.
Specifications
Type:
3-way bass reflex
Impedance:
6 h
Maximum input power:
150 W
Output sound pressure level: 90 dB/W/m
Frequency response:
30 Hz - 50 kHz
Crossover frequency:
420 Hz, 3.2 kHz
Cabinet capacity:
59.5 L
Speakers
Woofer:
11-13/16" (30 cm) cone type
Squawker:
4-3/4" (12 cm) cone type
Tweeter:
1-9/16" (4 cm) composite
dome type
Dimensions (W × H × D): 14-15/16" × 26" × 14-15/16"
(380 × 660 × 380 mm)
(incl. grille and projection)
Weight (per speaker):
56.22 lbs. (25.5 kg)
Terminal:
Gold-plated machined brass
screw terminals
(Banana type supported)
Accessories:
Cork spacer × 8
Other:
Non-magnetic shielding/
Bilaterally symmetrical design
0 Specifications and appearance are subject to change
for improvement without prior notice.
En-4
Advertisement
