Scan To Ftp Error Codes - Kyocera FS-3040MFP Service Manual

(2) Scan to FTP error codes

Code Display
1101 Error: Host name
1102 Error: User/Password
1103 Error: Path Name or
File Name
1105 Error: Not support
protocol
2101 Error: Can not con-
nect
2102 Error: Can not con-
nect with timeout
2103 Error: Response wait
with timeout
2201 Error: Network trans-
fer
2202 Error: Network trans-
fer with timeout
2203 Error: Response wait
with timeout
3101 Error: Server
response
9181 Error: Page max
count over
Causes
Enter the disable host
name/IP address.
Domain name is not
entered.
Assign disable user/pass-
word.
Connect to the folder
which is not permitted for
reference/writing.
Assign disable folder path.
FTP Protocol is set to OFF. Check ON in the [Scanner]-[FTP] screen in
Enter the disable host
name/IP address.
Assign the wrong port
number.
Network is not connected.
The server is unable to
communicate.
Send the server which
does not support FTP
server.
The server is unable to
communicate.
Error occurs on the net-
work.
Error occurs on the net-
work.
Response is not returned
from the server above
specified time.
The server is error status.
The number of pages of a
send file exceeded 999
pages.
1-4-28
Check procedures/corrective measures
Enter the correct host name or IP address.
Enter the user name with the form of either
[Domain¥User] or [Domain/User].
Enter the correct user name/password.
Enter correct user name/password.
Check the access limit of destination folder.
Enter correct folder path.
COMMAND CENTER.
Enter the correct host name or IP address.
Enter the correct port number.
Check if the server is operating properly.
Check the network connection (cable. net-
work condition within LAN, etc.).
Check if the server is operating properly.
Enter the correct host name or IP address.
Check if the server is operating properly.
Check the network connection (cable. net-
work condition within LAN, etc.).
Check the network connection (cable. net-
work condition within LAN, etc.).
Check the network connection (cable. net-
work condition within LAN, etc.).
Check if the server is working properly.
Set the number of pages as 999 or less.
2LW/2LX