Hitch and trailer
Hitch
Introduction
This chapter contains information on the following subjects:
Description
Adjusting the ready position
Fitting the ball head
Check proper fitting
Removing the ball head
Accessories
The maximum trailer drawbar load is 50 kg/h.
WARNING
Check that the ball head is seated correctly and is secured in the mount-
■
ing recess before starting any journey.
Do not use the ball head, if it is not correctly inserted into the mounting
■
recess and secured.
Do not use the towing equipment if it is damaged or incomplete.
■
Do not modify or adapt the towing equipment in any way.
■
Never release the ball head while the trailer is still coupled.
■
Keep the mounting recess of the towing equipment clean at all times.
■
Such dirt prevents the ball head from being attached securely.
CAUTION
Take care with the ball bar - there is a risk of paint damage to the bumper.
■
After removing the ball head, always place the cap on the mounting recess.
■
Note
Operation and maintenance of hitch
■
Tow the vehicle by means of the detachable ball rod
■
126
Driving
» page
139.
» page
174.
Description
126
127
127
128
128
Fig. 123 Remove cover cap: on the rear bumper / for the receiving shaft
129
Read and observe
The ball head can be removed and is kept in the spare wheel well or in a com-
partment for the spare wheel in the luggage compartment.
Support for the towing device
Clamps for removing the wheel trims
1
Cover in the rear bumper
2
13-pin power socket
3
Cover for the mounting recess
4
Dust cap
5
Ball head
6
Operating lever
7
Lock cap
8
Release pin
9
Fig. 124
Ball head
and
on page 126 first.
» Fig. 123
and
» Fig. 124