Table of Contents
Advertisement
11.4.6 SAS transmitters and receivers
A typical SAS differential copper transmitter and receiver pair is shown in Figure 20. The receiver is AC coupling to eliminate ground shift
noise.
TX
Transmitter
100
TY
Figure 20.
SAS transmitters and receivers
11.4.7 Power
The drive receives power (+5 volts and +12 volts) through the SAS device connector.
Three +12 volt pins provide power to the drive, 2 short and 1 long. The current return for the +12 volt power supply is through the common
ground pins. The supply current and return current must be distributed as evenly as possible among the pins.
Three +5 volt pins provide power to the drive, 2 short and 1 long. The current return for the +5 volt power supply is through the common
ground pins. The supply current and return current must be distributed as evenly as possible among the pins.
Current to the drive through the long power pins may be limited by the system to reduce inrush current to the drive during hot plugging.
11.5
S
IGNAL CHARACTERISTICS
This section describes the electrical signal characteristics of the drive's input and output signals. See Table 15 for signal type and signal
name information.
11.5.1 Ready LED Out
The Ready LED Out signal is driven by the drive as indicated in Table 16.
Table 16 Ready LED Out conditions
N
ORMAL COMMAND ACTIVITY
Ready LED Meaning bit mode page 19h
Spun down and no activity
Spun down and activity (command executing)
Spun up and no activity
Spun up and activity (command executing)
Spinning up or down
Format in progress, each cylinder change
The Ready LED Out signal is designed to pull down the cathode of an LED. The anode is attached to the proper +3.3 volt supply through
an appropriate current limiting resistor. The LED and the current limiting resistor are external to the drive. See Table 17 for the output
characteristics of the LED drive signals.
Table 17 LED drive signal
S
TATE
LED off, high
S
E
C
EAGATE
NTERPRISE
APACITY
Differential
Transfer Medium
(50% on and 50% off, 0.5 seconds on and off for 0.5 seconds)
T
EST CONDITION
0 V
VOH
3.6 V
3.5 HDD
4 SAS P
V
RODUCT
.01
RX
Receiver
100
RY
.01
LED
STATUS
0
Off
On
On
Off
Blinks steadily
Toggles on/off
O
UTPUT VOLTAGE
-100 μA < I
< 100 μA
OH
M
, R
. A
ANUAL
EV
1
Off
On
Off
On
61
Advertisement
Table of Contents
