Blind Spot Information (Bsi) System; Homelink - Acura 2013 TL Advanced Technology Manual

BLIND SPOT INFORMATION (BSI) SYSTEM

Assists you in determining if there are vehicles in your blind spots.
H o w I t W o r k s
A radar sensor on each corner of the rear bumper alerts you to a detected
vehicle in your blind spot.
Minimum operating speed: 6-7 mph
When a vehicle is detected in
your blind spot, the blind spot
indicator turns on and stays lit until
the area is clear.
When your turn signal is on and a
vehicle is detected, the blind spot
indicator blinks until the area is
clear or the turn signal is turned off.
T u r n i n g B S I O f f / O n
12
28
(Advance Package)
Left BSI indicator shown
Press and hold
the BSI OFF
button on the
dashboard to
turn BSI off or on.
A message
briefly appears
on the MID
screen showing
the system status.
H O M E L I N K ®
Program your vehicle to operate up to three remote-controlled devices around your
home, such as garage doors, lighting, or home security systems.
T r a i n i n g a B u t t o n
1
Position the remote transmitter you
wish to link 1–3 inches from the
HomeLink button you want to program.
2
Press and hold the desired
HomeLink button and the button on
the remote transmitter.
Does the HomeLink indicator (LED) blink at a
faster rate after about 10 seconds?
NO
a
Press and hold the button on the
remote and the HomeLink button at
the same time. Then, while
continuing to hold the HomeLink
button, press and release the button
on the remote every 2 seconds.
Does the LED blink at a faster rate within 20
seconds?
NO
If you have any problems programming HomeLink, see the owner's manual
included with the device you are trying to program, call HomeLink at
(800) 355-3515, or visit www.homelink.com.
3 Press and hold the programmed
HomeLink button for about a
second.
Does the device (garage door opener) work?
NO
4
Training
Press and hold
complete
the HomeLink
button again.
HomeLink indicator HomeLink LED
YES
flashes for 2 seconds,
remains on.
then remains on.
a
The remote has a rolling code.
Press the "learn" button on the
remote-controlled device (e.g.,
garage door opener).
b
Within 30 seconds, press and
hold the programmed HomeLink
YES
button for 2 seconds.
5
Press the programmed HomeLink
button again; the remote-controlled
device should operate.
YES
13
29