Table of Contents
Advertisement
are found, do not use tool until
repaired.
tool Set up
FROm aCCIDEntaL
OpERatIOn: turn tool off and
remove Battery pack before
performing any inspection,
maintenance, or cleaning
procedures.
tO pREVEnt SERIOuS
InjuRY: Do not adjust or
tamper with any control or
component in a way not
specifically explained within
manual. Improper adjustment
can result in tool failure or
other serious hazards.
Charging
1.
Please refer to the Charger manual
for important safety warnings and
proper instructions on charging the
Battery Pack (40).
2.
WaRnIng!
Do NOT use a different
Charger or Battery to power this Drill.
general Operating Instructions
note:
1.
When tool is not being used
or when battery, drills, or screwdriver
bits are being attached or removed,
slide Direction Selector (38) to its
mid-position to lock Trigger.
2.
note:
To change direction of rotation,
ALWAYS release Trigger allowing
motor to come to complete stop first.
3.
This Drill is designed to accept up to
3/8" shank size standard drill bits, as
SKU 67024
tO pREVEnt
SERIOuS InjuRY
For technical questions, please call 1-800-444-3353.
well as hex shank screwdriver bits
and bit holder adapters. Do not use
larger size drill bits as damage to
gears/motor may result. Always use
a drill bit that is designed for specific
drilling job
4.
Slide Direction Selector (38) to its
mid-position. While holding ring
behind collar of Chuck (2) with one
hand, rotate collar counterclockwise
to open jaws. Insert shank of drill
bit or hex shank of bit/adapter into
Chuck. Turn collar clockwise to hand
tighten (do not use pliers.)
5.
Turn Torque Selector (6) to the de-
sired setting and then slide charged
battery pack onto base of tool until
locked into position. Gently pull on
battery to ensure that it is locked
securely. Slide Direction Selector to
right for drilling / fastening or to left
for reversing.
6.
Place one hand over top of housing
for greater tool stability. With other
hand grip handle and gently squeeze
Trigger to activate motor. Use Cylin-
drical Vial Level (45) at rear top-side
and Circular Vial Level (46) on back
of the housing as alignment guides.
7.
Do not force bit. Excessive force will
damage tip and lead to tool failure.
8.
If drill bit becomes stuck, immediately
release Trigger allowing tool to come
to complete stop. Slide Direction
Selector to left to its reverse position
and squeeze Trigger.
9.
To prevent accident and injuries,
when not in use, remove the attach-
ment and the battery pack from the
tool.
Page 8
Hide quick links:
Advertisement
Table of Contents
