JBL EON 210P User Manual page 13

STEREO OUTPUTS: We've brought signals into the mixer now let's send
them somewhere...The EON 210P has 3 stereo pairs of outputs:
1. LEFT/RIGHT speaker outputs - These outputs should only be
connected to the EON 210P speakers and under no condition
should they be connected to the input of another electronic device.
These outputs carry power and as such could damage the electronic
device. Only use "unshielded" speaker cables (like the cables
provided with your EON 210P).
2. "MONITOR OUTPUTS"
These outputs allow you to route the stereo mixer signal to another
destination like a recording device, personal monitor, subwoofer
or to another PA system (Front of House). Depending on the input
connectors of the destination device, you can use either the ¼" phone
jacks or the RCA jacks.
a. "MONITOR OUTPUT VOLUME"
This controls the overall volume of the MONITOR OUTPUT.
3. HEADPHONE OUTPUT
This output allows the user to listen to the main output the EON 210P mixer.
Headphones used will require a 3.5 mm stereo plug.
MASTER VOLUME and "PEAK LED LADDER"
Your EON 210P is equipped with a "Master Volume" that controls the overall
output volume of the system and a 5 light "Peak LED Ladder" that gives you
a visual display of how much power you are using (think of the speedometer
on your car). The red or top LED on the ladder indicates that you are approaching
the maximum output by blinking or, when it stays on constantly, indicates you
have reached the maximum output. As a frame of reference if a channel volume
is on "7" and the "MASTER VOLUME" is on "7" you will have reached the
maximum output before distortion is audible.
ls
c
ons
October 5th, 2010
13