Table of Contents
Advertisement
18V CORDLESS ANGLE GRINDER
C-tick marking
RCM approval mark
Positive terminal
Negative terminal
The output plug is with positive center pole
and negative outer pole
TECHNICAL DATA
Battery voltage
Charger voltage
No load speed
Blade size
Cutting capacity
Cutting Depth at 90°
Cutting Depth at 45°
Bevel capacity
Battery capacity
Charging time
Machine weight
Charger protection class
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction
book carefully.
INTENDED USE
The machine is intended for lengthways and crossways
cutting of wood with straight cutting lines as well as
bevel angles to 50° while resting firmly on the work
piece.
1. CHARGING YOUR BATTERY PACK
A) CHARGING THE BATTERY
The battery charger supplied is matched to the Li-ion
battery installed in the machine. Do not use any other
battery charger.
The Li-ion battery is protected against deep
discharging. When the battery is empty, the machine is
switched off by means of a protective circuit: The tool
holder no longer rotates.
In a warm environment or after heavy use, the battery
pack may become too hot. Allow the battery to cool
down before recharging.
B) IMPORTANT NOTES FOR CHARGING THE BATTERY
The battery in your new tool is not charged when it
leaves the plant. Therefore it must be charged
before using the first time!
NOTE: If the battery pack is very hot you must remove
your battery pack from the tool and allow your battery
pack to cool first to ambient temperature and then
recharging can be started.
To prevent damage to the Battery Pack, when charge
runs out, please charge the battery to reach full or no
less than half charge before storage.
EN
18V
100-240V~ 50-60Hz
4000 /min
140 mm
40mm
26 mm
0-45
o
1.3Ah Li-Ion
3-5 hours
2.48 kg
/ll
11
Advertisement
Table of Contents
