Table of Contents
Advertisement
18V CORDLESS ANGLE GRINDER
MAINTENANCE
Remove the battery pack from the tool before
carrying out any adjustment, servicing or
maintenance.
Your power tool requires no additional lubrication or
maintenance.
There are no user serviceable parts in your power
tool. Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth. Always
store your power tool in a dry place. Keep the motor
ventilation slots clean. Keep all working controls free
of dust. Occasionally you may see sparks through the
ventilation slots. This is normal and will not damage
your power tool.
TROUBLESHOOTING
Although your new circular saw is really very simple
to operate, if you do experience problems, please
check the following:
1. If saw blade wobbles or vibrates, check if the
outer flange is tightened or if the disc is correctly
located on the flange plate.
2. Do not use the damaged blade as it may
disintegrate. Remove it and replace with a new
blade. Dispose of old blade sensibly.
3. A small amount of battery pack leakage may occur
under extreme temperatures or after heavy use.
Immediately wash any leakage from hands, skin or
clothes with soap and water.
4. The power-draw from the battery generates heat.
This is increased as the energy draw increases.
You will not damage the battery pack and the
generated heated heat is normal. Should you
desire to cool it down, simply allow the drill to
cool off prior to continuing work.
5. The battery pack may get warm when charging.
This is normal. It is a result from the stepping
down of the chemical reactions inside the
batteries during the charging process.
6. The charger will get warm during charging. This
is normal. It is a result of the stepping down of the
main supply.
14
DISPOSAL OF AN EXHAUSTED
BATTERY PACK
To preserve natural resources, please recycle
or dispose of the battery pack properly. This
battery pack contains Lithium batteries.
Li-Ion
Consult your local waste authority for information
regarding available recycling and/or disposal options.
Discharge your battery pack by operating your tool,
then remove the battery pack from the tool housing
and cover the battery pack connections with heavy-
duty adhesive tape to prevent short circuit and energy
discharge. Do not attempt to open or remove any of the
components.
Staple your purchase receipt here
Before returning this product for
warranty or any other reason, please call.
POSITEC AUSTRALIA PTY LIMITED
ABN 14 101 682 357
Unit 15, 23 Narabang Way Belrose 2085 NSW Australia
FREE CALL 1300 889 028
EMAIL:office.sales@positec.com.au
EN
Advertisement
Table of Contents
